HAT for Raspberry Pi with SIM7070G NB-IoT / Cat-M / Gprs / Gnss HAT

An extension for Raspberry Pi with a SIM7070G module enabling communication using NB-IoT and a built-in GNSS receiver allowing for reading navigation data from the following systems: GPS, GLONASS, Galileo. Additional pins on the module board allow for work with Arduino\STM32. Features: 40 pin GPIO connector for Raspberry Pi Supported protocols TCP/UDP/http/https/TLS/dtls/ping/LWM2M/coap/mqtt GPS, BeiDou, glonass, Galileo positioning USB interface, allowing testing AT commands, reading GPS data, etc. UART interface for Arduino/STM32 connection SIM card slot, only 1.8V SIM cards are supported LED indicators, for easy monitoring of communication status Baudrate: 300~3686400 bps Available operation examples for Raspberry Pi/Arduino/STM32 NB-IoT/Cat-M/2G Band NB-IoT specification: B1/B2/B3/B4/B5/B8/B12/B13/B18/B19/B20/B25/B26/B28/B66/B71/B85 Cat-M: B1/B2/B3/B4/B5/B8/B12/B13/B14/B18/B19/B20/B25/B26/B27/B28/B66/B85 GSM/gprs/edge: 850/900/1800/1900MHz Data rate NB-IoT: 136Kbps(DL)/150Kbps(UL) Cat-M: 589Kbps(DL)/1119Kbps(UL) gprs: 85.6Kbps(DL)/85.6Kbps(UL) edge: 236.8Kbps(DL)/236.8Kbps(UL) SIM card support NB-IoT/Cat-M/2G card (1.8V SIM card only) Applicable region global gnss Receiver type 16-channel C/A Code Band GPS L1: 1575.42 ± 1.023MHz glonass L1: 1598.0625 ~ 1605.375MHz BDS B1: 1559.052 ~ 1591.788MHz Galileo L1: 1575.42 ± 1.023MHz Data format nmea-0183 Antenna Active antenna Other Power supply 5V Operating voltage 5V / 3.3V (configured via 0Ω resistor) Current consumption about 41mA (idle mode) Operating temperature -40°C ~ 85°C Storage temperature -45°C ~ 90°C Dimensions 30.50mm × 65.00mm Raspberry Pi connection example Standard 40 PIN GPIO connector Board description SIM7070G MP1482 power supply RT9193-33 power supply GPIO connector Raspberry Pi for connecting to Raspberry Pi USB connector for testing with AT commands, reading GPS data, etc. SIM7070G control interface for connecting to Arduino/STM32 SIM card slot only 1.8V SIM cards supported GNSS antenna connector (GPS) LTE antenna connector Module power switch Network status indicator Power indicator Operating and control voltage selection A: voltage on IO lines 5V B: voltage on IO lines 3.3V (default) DTR setting A: DTR connected to P26 B: DTR disconnected (default) PWR selection A: PWR connected to P4 (default) B: PWR connected to power supply Pinout Dimensions Kit includes: HAT for Raspberry Pi with SIM7070G LTE antenna GPS antenna USB cable Mounting spacers Wiki: SIM7070G_Cat-M/NB-IoT/GPRS_HAT