Automatic Water Controller, Non Contact Capacitance Induction Technology with Relay Dry Contact Output, for Pump Control AC100V to 260V

Overflow Detection Function: The default wiring is water ingress detection. If you want the overflow detection function. What you need to have power on the alarm output terminals, the C terminal on the pump output and the C terminal on the alarm output need to be connected. Then connected them with a wire. you have the overflow working properly as described in the documentation, the black wire from the sensor needs to be moved and connected to the blue terminal together with the blue wire. Intelligent Control: When the liquid of the container is too low, the low liquid alarm signal from the low liquid sensor is triggered to trigger the controller to close the relay to start the to add liquid . When the liquid reaches a certain height, the high liquid sensor sends a signal to trigger the controller to disconnect the relay to automatically stop the . You can use the controller to either to fill or empty a . Non Contact Induction Probe: Water controller adopts non contact capacitance induction technology and special induction control chip design, the probe is , strong anti interference ability, sensitive induction, no contact with liquid, corrosion resistance, , environmental and no pollution. Item Type: Automatic Water Controller Material: ABS Model: XKC C352 3P ( automatic water control and inlet or overflow detection) Input Voltage: AC100V to 260V, 50 or 60Hz Working Current: Working current less than 110mA, static current consumption less than 20mA Load power: Resistive loads up to 1.6KW (overload or for three phase loads require an AC contactor) Inductive loads below 1KW (overload or for three phase loads require additional AC contactors) Inductive loads are loads with inductive coils, such as motors, solenoids, solenoid valves, etc. Alarm Output: 800W (resistive load) normally open or normally closed output Output Mode: Normally open or normally closed output Input Signal: Inductive signal input Induction Head Interface Voltage: 12V Working Temperature: -20 to 105 celsius Size: Approx.115 x 90 x 40mm Celsius 4.53 x 3.54 x 1.57in